How To Quiet a Noisy Hot Water Heating System

If you have a hot water baseboard heat, you surely understand the fact that noise is one of its most typical setbacks. There could be several reasons as to why there is noise coming from the hot water heating system. This goes to show that it is best to solve the problem by means of responding immediately.

It is very easy to quiet a noisy hot water heating system. All you have to do is to keep the fill valve open while opening the drain. Follow the following steps in order to quiet a noisy hot water heating system without any difficulty.

One reason why the hot water heating system is making too much noise is because the metal pipes are expanding and contracting. This usually happens when there is still a clicking sound when the heat happens on especially when fresh water is contained in the system. A great way to deal with this is to use graphite lubrication whenever the supports are producing clicks.

  • Do not be afraid to be a plumber yourself. Not only will it save you a great deal of money, it will only enhance your mechanical skill. In order to put a remedy to the problem, create an arrester for the system. An arrester is a vertically capped pipe stub that is eight inches long and functions as an air cushion. The noise is due to the pressure brought about by the blockage of the flow of the water. Furthermore, there is compression as far as the water is concerned. To stop the noised, the air within the pipe stub must be compressed.
  • Before you slash the copper pipe, turn off the water mains first. The system must also be drained. After that, it is time for you to slash the pipe where the arrestor must be. Do not forget to dry off the pipe. After cutting the piece of pipe, make sure that both of its ends are dirt free. You can do so by means of an emery cloth that is utilized to get rid of stain. Apart from the pipe, clean also the cap and the T-joint.
  • When it comes to cleaning, keep in mind that you must observe sanitation by wearing gloves. After cleaning the materials needed, insert the cap on the pipe. It is then time to even out a foot worth of solder. Heat the pipe with the use of the torch. The solder must be fed around the cap when the melting is quick. Do this in anticipation of beading its edge. Cool down the pipe for a moment before repeating this step on soldering the T-joint.
  • The arrestor must be on the dry part of the inside of the water pipe. For the pipe ends, clean it with the emery cloth. For the T-joint, brush it with flux, and then put it together with the pipe ends. Even out solder, then turn on the torch to light it. The last part is to sweat the arrestor within the system.

Remember that the system must be dried first before you turn it on. Drain the air by filling in the system. Regularly check your system to prevent any noise again.


Share this article!

Follow us!

Find more helpful articles: