What is a home without hot-water heater? Hot-water heater is necessary in every home because it is used in bathing, laundry, washing dishes and so on. Hot-water heaters are usually located in the garage or basement and are installed along with water pipes and water engine that help give steady supply of water to the entire household. Because it is somewhat hidden, a hot-water heater is commonly taken for granted and is not consistently maintained. But since it is a vital tool in running a home, you should at times check its state to know if it is functioning to its maximum capacity. Find out if your hot-water heater is not working by following these steps:
- Run your hot-water heater. To find out if it has defects, turn on your hot-water heater and let it run for a while. At the same time, turn on a faucet and let the water flow to see if the heater is working.
- Test the water temperature. Place your hand under the faucet with your palm up. Determine if the water is getting hot to a desired temperature. Adjust the heat level occasionally to know if this function also works. If the water in this port is not getting hot, open another tap and see if the water coming from it is hot.
- Find out if there is someone using hot water in the house. Some hot-water heaters cannot sustain heat when there are several users in the house. For instance, if you are taking a shower and another family member is washing the dishes or doing the laundry, the hot-water heater can provide only enough heat to everyone. Hence, the heat is distributed to all users, thereby the heat is lessened.
- Inspect the current breaker. Hot-water heaters are run by electricity. If it does not seem to work, check the breaker and see if it is in proper condition. If the breaker suffers some problems like breakage in the switch, repair it at once. On the other hand, if the breaker is in top condition, then the hot-water heater must be the problem.
- Check if there are sediments in the hot-water heater tank. With sediments clogging the tank, chances are, your heater will not function well. You will know if there are sediments with the yellowish color of the water. The remedy for this is to drain and clean the tank and replenish with clean water.
- Make sure the plumbing attachments of the water heater are in good condition. Sometimes the efficiency of hot-water heaters depends on the plumbing set up. If you sense any noise coming from it, have it checked by an expert plumber. For all you know, the noise may come from the built up steam coming from the water heater.
- Examine the electrical connections of the hot-water heater. In time, electrical wirings may loosen. Check any flailing or exposed wirings. This is very important not only to ensure your hot-water heater is functioning properly, but for safety of the whole household as well.
For a more efficient hot-water heater set up, make sure the heater unit has enough capacity to supply hot water for the entire house or building. Also, when installing the heater, you must note down all the connections so when you need to troubleshoot, you can easily trace the problem.