This video shows how to repair your broken iPod video 5th Generation LCD screen by replacing the faulty screen and installing a new one. This part and many others can be found on our website.

Video Transcription

Sharpen the output video. Capsize produle and run it along the sides so it will release the clips. Once since this is done, you should just out there, carefully falls apart. Be careful because it is still connected with ribbons inside. Before you can open the case fully we need to release the battery connector here. There is a small brown clip that just simply needs to be lifted up and then you can release the ribbon. You can now open the ipod video. Next is the hard drive, it just needs to be pushed forward, this prevails a small clip, this just needs to be lifted up so you can release the hard disk ribbon. I am doing this with a pair of tweezers, you can now carefully pull out the ribbon to release in the hard drive. The next ribbons to be removed are done exactly the same way. Just lift p the clip and release the cable. The next step is to remove six more screws from the side of the ipod, that is for your next side that is pointed out here. [Demo] Once all the screws are removed, put the ipod back on its front and remove the ipod video LCD screen ribbon, again lift the clip and then gently pull the ribbon out. The next step is to remove the LCD, to do this simply unclip the two bits of plastic within the small opening at the top and pull the LCD screen out. [Demo] To fit the new screen simply place back in between the frame and reconnect the ribbon, simply push this in the connection and close down the black clip. [Demo]