How to Install PSP Replacement LCD Screen Display

This video shows how to install a PSP Replacement LCD Screen Display. You may need to do this if you have a broken, cracked or damaged LCD screen.

Video Transcription

This short video shows how to replace the LCD screen of your PSP. In case you damaged it or cracked it. Our first we need to do is remove the battery from the unit which will reveal some screws which then needs to be removed also. There is seven of this inside so some each sides and one on the bottom, all of this can be remove with a small Philip screwdriver. [Demo] Once you have removed all the screws from the back, turn the PSP over and you should just be out too slowly pull of the front of the PSP. The next step is to remove the small bar at the bottom. Just pull this down and then lift this up to reveal a small clip holding the ripping in. This just needs to be lifted up. You can use a small pair of tweezers that is shown in the video or small screwdriver. Once this has been lifted, you can just remove the rigger. [Demo] This next step can sometimes be a little tricky, there is four metal clips holding in the screen to each side. The best to do is get a kitchen as shown in the video and just try to unclip this. This needs do one side, unclip both and then it should be out to easily lift out. [Demo] Once you have both clips on top, just gently lift the screen up and move it forward. The screen is being connected to the motherboard in two places. There are two clips and both of these needs to be lifted up before the ribbon can be removed. [Demo] As set, the screen is now removed, we are ready to replace. Simply put the new screen and reversing the steps that we have shown you in this video.